Test T

PINPOINT TEST T: THE POWER SLIDING DOOR IS INOPERATIVE - NO DTCS ARE RETRIEVED (RIGHT)

Test T1:

Test T2-T5:

Test T5-T7:

Test T7-T9:

Test T9-T12:

Test T12-T13:

Normal Operation
Pressing the overhead console right PSD open/close switch supplies a momentary ground signal on circuit 1237 (LG/RD) to the SJB. Then the SJB sends a signal on circuit 1430 (TN/RD) to the RPSDM. The RPSDM will open the power sliding door by providing 12 volts to the motor and clutch, if conditions are correct, or close the power sliding door.

Possible Causes
- circuit 1246 (LG/RD) short to ground or open
- circuit 1252 (GY/RD) short to battery or open
- circuit 1251 (YE/RD) short to battery
- PSD motor circuit (RD) short to ground
- PSD motor circuit (DB) short to ground
- low battery voltage
- PSD drive assembly actuator
- PSD module
- SJB
- BEC