Front Door Window Regulator: Service and Repair

DOOR WINDOW GLASS - FRONT

Heavy Duty Riveter:

SPECIAL TOOL(S)

REMOVAL
1. Remove the front door trim panel.
2. Position the watershield aside.










3. Remove the parts in the order indicated in the illustration and table.

To remove individual components, only carry out the listed steps.

4. To install, reverse the removal procedure.

Item 1: Rivet Removal Note

1. Connect the window control switch.
2. Connect the battery.






3. Position the door window glass halfway down to gain access to the door window glass rivets.
- Remove the rivets.

Item 4: Rivet Removal Removal Note

1. Remove the rivets.

Item 5: Front Door Window Regulator Removal Note

1. Disconnect the electrical connector.

2. WARNING: Prior to power window motor removal, make sure the regulator arms are in a fixed position to prevent counterbalance spring unwind. Failure to place the regulator arms in a fixed position can cause the spring to suddenly release resulting in personal injury.

NOTE: The counterbalance spring assists the window in the upward direction.

Remove the bolts and the window regulator motor.

Item 4: Rivet Installation Note






1. Using the special tool, install the rivets.

Item 1: Rivet Installation Note






1. Using the special tool, install the rivets.