Camshaft Position (CMP) Sensor

CAMSHAFT POSITION (CMP) SENSOR

Removal and Installation
1. Disconnect the battery ground cable.







2. Remove the accelerator cable snow shield.
- Remove the pin-type retainers.
- Remove the accelerator cable snow shield.







3. Detach the spark plug wire retainer.







4. Detach the wiring harness from the intake manifold support.







5. NOTE: The upper intake manifold is removed for clarity.

Release the fuel charging wiring harness from the valve cover studs. Position the wiring harness away from the camshaft position sensor.







6. Remove the camshaft position (CMP) sensor.
1 Disconnect the electrical connector.
2 Remove the screws and the CMP.







7. NOTE: Make sure that the fuel charging wiring harness is fully secured to the valve cover studs.

To install, reverse the removal procedure.