Operation CHARM: Car repair manuals for everyone.
Home >> Mercury >> 2007 >> Milan FWD L4-2.3L VIN Z >> Repair and Diagnosis >> Starting and Charging >> Starting System >> Ignition Switch >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Switch: Service and Repair

Ignition Switch

Ignition Switch:





Removal and Installation

CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.

1. Depower the supplemental restraints system (SRS). For additional information, refer to Air Bag Systems.

2. NOTE: The instrument panel steering column cover is held in place by tabs that clip to the instrument panel.

Remove the instrument panel steering column cover by pulling straight outward.

3. NOTE: Release the upper steering column shroud, by pressing inward on the sides of the shroud and lifting upwards.

Remove the upper steering column shroud.
4. Release the tilt lever, remove the 3 screws and then remove the lower steering column shroud.

5. NOTE: Lower the steering column to the lowest tilt position.

Disconnect the ignition switch electrical connector.
6. Press the 2 tabs and remove the ignition switch.
7. To install, reverse the removal procedure.
8. Repower the supplemental restraints system (SRS). For additional information, refer to Air Bag Systems.
pro multis · About Operation CHARM