Lateral Accelerometer: Service and Repair

Stability Control Sensor Cluster

Stability Control Sensor Cluster:

Removal and Installation

WARNING: Wear high-voltage insulated safety gloves and a face shield when working with high-voltage batteries or cables. The high-voltage insulated safety gloves should be of the appropriate safety and protection rating. Inspect the gloves before use and always wear them with the leather outer glove. Any hole in the rubber insulating glove is a potential entry point for high-voltage. Failure to follow these instructions may result in serious personal injury or death.

1. Disconnect the battery ground cable.
2. Remove the floor console.

3. NOTE: When installing the sensor cluster the electrical connector must face the passenger seat.

Disconnect the electrical connector.
4. Remove the 2 sensor cluster bolts.
^ To install, tighten to 10 Nm (89 lb-inch).
5. Remove the stability control sensor cluster.
6. To install, reverse the removal procedure.