Extension Housing Gasket

Extension Housing Gasket - Four Wheel Drive (4WD)

Extension Housing Gasket - Four Wheel Drive (4WD):

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Support the transmission with a suitable jack.
3. Remove the transfer case.

4. CAUTION: The parking pawl, parking pawl return spring and parking pawl shaft may fall out during removal of the extension housing.

Remove the extension housing.





5. Remove and discard the extension housing gasket.





Installation
1. Clean the extension housing and install new extension housing gasket. Make sure that the park pawl is installed correctly.





2. NOTE: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.

Install the extension housing.
^ Tighten to 30 Nm (22 lb-ft).





3. Install the transfer case.
4. Remove the transmission support.
5. Carry out the transmission fluid level check. Transmission Fluid Level Check