Transmission Mount: Service and Repair

Transmission Support Insulator -Four Wheel Drive (4WD)

Transmission Support Insulator - Four Wheel Drive (4WD):

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If equipped, remove the skid plate bolts and the skid plate.
3. Support the transmission with a transmission jack.
4. Remove the 2 transmission support insulator nuts.





5. NOTE: Crossmember and exhaust system shown removed.

NOTE: LH shown, RH similar.

Remove the 2 transmission support insulator bolts.





6. Raise the transmission and remove the transmission support insulator.

Installation
1. Install the transmission support insulator and the 2 transmission support insulator bolts.
^ Tighten to 90 Nm (66 lb-ft).





2. Lower the transmission and install the 2 transmission support insulator nuts.
^ Tighten to 90 Nm (66 lb-ft).





3. If equipped, install the skid plate and bolts.
^ Tighten to 24 Nm (18 lb-ft).