60 Percent, Bench
SEAT BACKREST COVER - SECOND ROW, 60 PERCENT, BENCHExploded View
Second Row, 60 Percent E-Z Entry Backrest (Part 1):
Second Row, 60 Percent E-Z Entry Backrest (Part 2):
Second Row, 60 Percent, E-Z Entry Cushion (Part 1):
Second Row, 60 Percent, E-Z Entry Cushion (Part 2):
Second Row, 40 Percent E-Z Entry Backrest:
Second Row, 40 Percent, E-Z Entry Cushion (Part 1):
Second Row, 40 Percent, E-Z Entry Cushion (Part 2):
Second Row, Bucket, Backrest:
Second Row, Bucket, Cushion (Part 1):
Second Row, Bucket, Cushion (Part 2):
Second Row, 60 Percent Bench, Backrest:
Second Row, 60 Percent Bench, Cushion:
Second Row, 40 Percent Bench, Backrest:
Second Row, 40 Percent Bench, Cushion:
Removal and Installation
All vehicles
1. Remove the second row 60 percent seat of the 60/40 bench seat.
2. Using an appropriate tool, push in the hole of each head restraint guide while lifting up and remove the head restraint.
3. Remove the safety belt anchor bolt.
- To install, tighten to 75 Nm (55 lb-ft).
4. Pull out at the bottom and remove the safety belt guide cover.
Sport Trac vehicles
5. Remove the 4 screws and the upper latch cover.
All vehicles
6. Remove the screws and the upper latch cover.
7. Release the backrest trim cover J-clip.
8. Remove all the staples in the backrest support panel.
9. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat backrest foam pad.
Separate the hook-and-loop fasteners, invert the backrest trim cover and remove the hog rings.
10. NOTE:
- The inboard and outboard head restraint sleeves are not interchangeable.
- The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
11. Separate the hook-and-loop fasteners. Remove the backrest trim cover.
- Feed the safety belt out through the backrest trim cover.
12. To install, reverse the removal procedure.