Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor

















Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the Crankshaft Position (CKP) sensor electrical connector.

3. Remove the bolt and the CKP.
- To install, tighten to 10 Nm (89 lb-in).

- Inspect the O-ring seal and install new as necessary.

4. NOTE: Lubricate the CKP O-ring seal with clean engine oil.

To install, reverse the removal procedure.

5. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.