Alternator: Service and Repair

Removing And Installing/Replacing Alternator


NOTE: Read out fault memory of EMS2000 control module, check stored fault memory, rectify faults, clear fault memory.


Disconnect battery ground wire.
Remove alternator drive belt.
Remove intake manifold.







Disconnect electrical connector (1).
Tightening torque 10 Nm.
Disconnect electrical connector (2).







Remove alternator retaining bolts (1).
Tightening torque 25 Nm.


NOTE: Read out fault memory of EMS2000 control module, check stored fault memory, rectify faults, clear fault memory.