Transmission Position Sensor/Switch: Service and Repair
24 10 006 - Removing and installing/replacing gear position switch (AISIN)
Special tools required:
- 24 4 270
Necessary preliminary tasks:
- Remove intake filter housing
- Remove intake neck for intake filter housing
- Disconnect gear position switch plug
Release screws (1).
Disconnect connector (2).
Release cable lock nut (1).
Tightening torque 24 11 8AZ [1][2]Fluid Pan, A/T.
Press retaining clip (1) together and remove cable from fixture (2).
Release shim (1), retaining ring (2) and nut (3).
Release screws (4).
Remove switch.
Installation:
Insert screws (4) slightly.
Fit shim, retaining ring and nut.
Tightening torque 24 11 12AZ [1][2]Fluid Pan, A/T.
Mount special tool 24 4 270.
Tighten screw (1).
Align position switch to "N".
Tighten down screws (2).
Tightening torque 24 11 12AZ [1][2]Fluid Pan, A/T.
Installation:
Connect gear position switch plug
Installation:
- Move selector lever to ''P'' position
- Grip clamping sleeve (1)
- Slacken nut (2).
- Press shift lever (3) into park position, then release again
- Press cable (4) in direction of arrow, then release again
- Grip clamping sleeve (1) and tighten down