Manifold Pressure/Vacuum Sensor: Service and Repair

13 62 010 Removing and installing/replacing fuel differential pressure sensor (N12, N16)







Necessary preliminary work:
- Remove intake silencer housing.
- Installation location: On intake plenum, left side.







IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).







Unlock connector (1) and remove.
Release screw.
Pull fuel differential-pressure sensor (2) out of intake plenum.

Installation note:
- Check sealing ring, replace if necessary.
- Tightening torque 13 62 1AZ .







Installation note:
Check stored fault messages.
Delete fault memory.