Ignition Coil: Service and Repair
12 13 513 - Replacing ignition coil
Necessary preliminary tasks:
- Switch off ignition
- Read out fault memory of DME control unit
- Check stored fault messages
Unlock plug (1) and remove.
Detach ignition cable (2) from ignition coil.
Release screws (3).
Installation:
Screw (1) and spacer tube (2) are only available as a single set.
Check insulating rings (3), replace if necessary.
Tightening torque 12 13 1AZ [1][2]Ignition Coil.
Note:
Now clear the fault memory.