34 00 025 Replacing Fluid In ABS/ASC+T Brake System

34 00 025 Replacing Fluid In ABS/ASC+T Brake System







NOTE: Read and comply with General Information.







IMPORTANT: When carrying out repairs to the brake system, follow the procedure set out in Bleeding brake system with DSC.

Always use MINI-approved brake fluids, refer to MINI Operating Fluids.







Open cover (1).
Connect bleeder unit to expansion tank (2) and switch on.

IMPORTANT:
Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.







Fully rinse the brake system
Connect vent hose with collecting vessel to vent valve on rear right brake caliper.
Open vent valve and purge until clear, bubble-free brake fluid emerges.
Close vent valve.
Follow same procedure on rear left, front right and front left wheel brake.







NOTE:
The clutch slave cylinder must be scavenged in cars with manual transmissions.







Switch off bleeder unit and remove from expansion tank.
Check brake fluid level. If necessary, top up/draw off to max. level.
Close expansion tank.

NOTE: Pay attention to rubber seal (1) in sealing cap.