00 00 610 Engine Oil Service

00 00 610 Engine Oil Service (N14)







The FRU item 00 00 610 comprises the engine oil service incl. supplementary service.
Only the engine oil service will be described in these repair instructions.
The supplementary service is made up of the following operations which must be taken from the relevant repair instructions:
- Carry out function check on parking brake
- Reset service interval indicator according to factory specification







IMPORTANT:
Perform engine oil service only when engine is at normal operating temperature (>70 °C engine oil temperature).
Observe the exact engine oil filling capacity.
Overfilling the engine with engine oil will result in engine damage.
Inspection and drain-off times must be observed.







WARNING:
Danger of scalding.
Carry out work on the vehicle only when wearing oil- and heat-resistant protective gloves incl. forearm protection, face guard and protective apron.







Recycling:
Catch and dispose of drained engine oil in a suitable container.
Observe country-specific waste-disposal regulations.







NOTE:
Adhere to the following work steps in sequence:
1. Open oil filter cap.
2. Release screw plug in oil sump.







Release screw (1).
Tightening torque 17 00 2AZ.
Place expansion tank (2) in direction of arrow to one side.







NOTE: Catch any escaping engine oil with suitable means below the oil filter housing.

Slowly release oil filter cap (1) with a suitable tool.
Tightening torque 11 42 1AZ.

NOTE: Engine oil flows out of the oil filter housing and back into the oil sump.







Remove and insert oil filter element (1) in direction of arrow.

Installation:
Replace oil filter element (1) and sealing ring (2).

NOTE: Moisten sealing ring (2) with engine oil.







Remove screw plug (1) from oil sump and drain engine oil.
Tightening torque 11 13 1AZ.

Installation:
Replace sealing ring.
Assemble engine.
Pour in engine oil.

NOTE: Start engine and run at idle until oil pressure warning lamp goes out.

Turn off engine.
Check oil filter cap and screw plug (1) on oil sump for leaks.







Checking engine oil level:
- Park vehicle on a horizontal surface
- Using the dipstick, check the engine oil level after five minutes on the engine at normal operating temperature
- Top up engine oil if necessary