Keyless Start Antenna: Service and Repair

66 12 100 Removing And Installing (Replacing) Slide-In Unit For Radio-operated Key (Start/Stop Switch)

Special tools required:







IMPORTANT:
In the event of complaint "slide-in unit for radio-operated key jams or can not be retained", carry out following checks before replacement:

1. Check both sides of plug connection of ribbon cable (1) to slide-in unit for radio-operated key (4) for correct locking (3).
2. Check ribbon cable (2) for damage.

If required, lock plug connection of ribbon cable (1) correctly and carry out function check.
If this rectifies fault pattern, do not replace slide-in unit for radio-operated key.







Necessary preliminary tasks:
- Remove knee protection, right driver's side







Lever out cover (1) in direction of arrow using special tool 00 9 340 at retaining points (2).







Release screws (1).
Remove slide-in unit for radio-operated key (2).







Installation note:
Make sure clasps (1) are correctly seated, replace clasps (1) if necessary.