37 14 512 Replacing Rear Ride-Height Sensor

37 14 512 Replacing rear ride-height sensor







IMPORTANT: Observe safety instructions for raising the vehicle

NOTE:
Ride-height sensor holder on rear axle carrier 37 14 3AZ.
Jointed rod to holder 37 14 4AZ.
Holder to upper control arm 37 14 5AZ.







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD protection).







Necessary preliminary tasks:
- Partially detach underbody panelling







Disconnect plug connection (1).
Release nut (2) and remove jointed rod from sensor lever (3).

Installation:
Replace self-locking nut.
Sensor lever (3) must point from ride-height sensor to lower control arm.
Tightening torque 37 14 4AZ.







Release screws (1) and remove ride-height sensor.

Installation:
Tightening torque 37 14 1AZ.







After installation:
- Check headlight adjustment, correct if necessary