Transmission Position Sensor/Switch: Service and Repair

24 10 006 Removing and installing/replacing gear position switch (AISIN)

Special tools required:







IMPORTANT: An incorrectly adjusted gearshift mechanism can result in tooth meshing noise.







Necessary preliminary work:
- Remove air intake silencer housing
- Remove intake silencer housing gaiter.







Release cable lock nut (1).

Installation note:
Adjust gearshift mechanism.

NOTE: Graphic similar.







Disconnect connector (1) from transmission position sensor.
Unlock retaining sleeve (3) in direction of arrow.
Remove cable upwards from holder.
Release nut (4) and remove selector lever.
Tightening torque 24 11 6AZ.







Release washer (1), lock washer (2) and nut (3).
Release screws (4).
Remove switch.

Installation note:
Insert screws (4) slightly.
Fit washer, lock washer and nut.
Tightening torque 24 11 12AZ.







Mount special tool 24 4 270.
Tighten screw (1).
Align gear position switch to "N".
Tighten down screws (2).
Tightening torque 24 11 12AZ.

Installation note:
Connect gear position switch connector

׉�: