67 62 ... Notes on Initializing Power Window

67 62 ... - Notes on initializing power window





Warning!
Risk of injury!
There is no anti-trapping protection during initialization.





An initialization must be performed:
- In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
- After replacing drive for power window
- After work is carried out on the power window mechanism
- If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door
- After the door window glass has been removed and installed or replaced
- After adjustment work on the door window glass
- After adjustment work on the convertible top
- After replacement of seals





Initialization is performed on the power window switch of the relevant door.
Requirements for correct initialization:
- Terminal "R" activated
- Doors and windows closed
- Sufficient battery voltage; connect charger if necessary
Initialization comprises:
- Erasure of initialization
- Reinitialization





Erasure of initialization:
- Move door window glass into middle position
- Disconnect plug connection for power window flat motor or remove plug-in fuse for power window flat motor
- Actuate power window switch several times
This clears initialization of the power window. Anti-trapping protection and one-touch control (toll) function are inactive.
Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.
Reinitialization:
- Open door window glass fully
- After reaching lower end position, move without interruption to upper limit and hold switch for at least 2 seconds in "Close" position (second switch position)
This completes initialization.

Note:
Carry out function check (one-touch control function, anti-trapping protection and, if necessary, comfort function).





Note:
The power window can also be initialized in the BMW diagnosis system by means of a diagnosis job.