34 11 000 Removing and Installing/Renewing Brake Pads on Both Front Disc Brakes (Brembo)

34 11 000 Removing And Installing/Replacing Brake Pads On Both Front Disc Brakes (Brembo)

Special tools required:







IMPORTANT:
- Brake pad wear sensor: after removal it must be replaced (brake pad wear sensor loses its retention capability in the break pad).
- Expanding spring and retaining pins: for vehicles older than 48 months it is recommended to replace the retaining spring.

So as not to damage the surface coating, if possible do not mechanically clean the guide surfaces for the brake pads on the brake caliper mounting bracket. Instead, clean with brake cleaner BMW part no. 83 19 2 154 780.







Necessary preliminary tasks:
- Remove front wheels
- Remove brake pad wear sensor







Pull brake pad wear sensor (1) towards front out of pad (left side only when replacing brake pads).
Drive out retaining pins (2).
Remove expanding spring (3).
Remove brake pads (4).

IMPORTANT:
Mark any worn brake pads.
In the event of one-sided brake pad wear, do not change brake pads round.
Do not grease backs of brake pads sleeve.

Clean brake pads.







Check minimum brake disc thickness:
- Position special tool 34 1 280 at three measuring points in area (1) and measure.
- Compare measuring result and lowest value with setpoint value.







IMPORTANT: New brake pads may only be fitted if the brake disc thickness is greater than the minimum brake disc thickness (MIN TH).







Press brake piston fully back with special tool 34 1 050.

IMPORTANT:
When pressing piston back, note brake fluid level in expansion tank.
Overflowing brake fluid will damage the paintwork.







Check dust boot (1) for damage and replace if necessary.
Clean brake caliper channels (2).

IMPORTANT: Do not grease brake pads and guides with brake pad paste.







NOTE:
After completing work:
- Fully depress brake pedal several times so that brake pads contact brake discs.
- When installing new brake pads at front and rear axles, brake fluid level must be brought up to "MAX" marking.
- Read and comply with notes on braking in new brake discs / brake pads.
- If necessary, when replacing pads, reset CBS display in accordance with factory specification.