31 11 001 Replacing Front Axle Carrier

31 11 001 Replacing Front Axle Support







NOTE:
Replace self-tapping screws for mounting following components on front axle/engine support.
- Steering box
- Holder, wishbone / retaining bracket, anti-roll bar
- Bumper holder
- Holder, ride height sensor
- Front axle support (if replacing engine supports)







Necessary preliminary tasks:
- Lower front axle support.
- Remove both track rod ends from swivel bearing
- Remove both wishbones from swivel bearing.
- Remove both anti-roll bar links from anti-roll bar.







R60 N47:
Unlock and detach fuel delivery and return line (1 and 2).
Thread out fuel lines between front axle support and anti-roll bar in the direction of the engine.

Recycling:
Catch and dispose of escaping fuel.
Observe country-specific waste disposal regulations.







Installation note:
Use previous front axle support as a template for modifying or replacing small parts.

Modify stabilizer.
If necessary, modify ride height sensor.
Modify both wishbones.
Modify steering box.
Modify both bumper holders.







After installation:
- Carry out wheel alignment procedure.