Procedure For Input of Security Code For Radio and Tape Player

The radio, tape player and CD player does not operate in the following states.
1. Power supply to the radio, tape player and CD player has been suspended for more than one hour continuously by removing the cable from the battery terminal or disconnecting the harness connectors.
2. The power supply to the radio, tape player and CD player has been suspended for more than one hour owing to blown fuse or discharged battery.
3. The radio, tape player and CD player has been replaced.

If the radio, tape player and CD player does not operate for these causes, input the security code by the following procedure to operate it.











1. Using any of the following methods, confirm the anti-theft code.
a. Read the anti-theft code indicated on the cards retained by the user.
b. If the anti-theft code is unknown owing to the user's loss of the cards.
- Remove the radio, tape player and CD player.
- Read the serial no. shown on the name card of the radio and tape player.
- Look up the anti-theft code corresponding to the serial number in the serial number-anti-theft code table; or, make inquiries to Mitsubishi Motor Sales of America, Inc.
c. When the radio, tape player and CD player is replaced Read the security code on the cards attached to the upper surface of the replacement radio, tape player and CD player.

NOTE: Deliver the cards (two) to the user.




2. Connect the radio, tape player and CD player to the vehicle harness.
3. Turn the ignition key to the "ACC" position.
4. Press the POWER button, and "code" will be displayed on the display.





5. Press No. 1 through No. 4 memory select buttons and set the 4-digit security code indicated on the card.
6. Press the tape player button. After a beep is heard, the radio , tape player and CD player will be in the operating state.
7. If the input security code does not agree with that in memory, "1 Err" is displayed on the display. In a few seconds, it will change to "code". So, repeat steps 5 and 6.

NOTE:
1. The security code can be set three times at the most.
2. The second error is displayed as "2 Err". If the third error is made, "3 Err" is displayed and then it changes to "OFF".
3. When setting is attempted four or more times, keeping the ignition key in the "ACC" or "ON" position for about one hour will automatically erase the "OFF" display.After the erasing, therefore, repeat step 3 and up.