Operation CHARM: Car repair manuals for everyone.

90000 MI or 144000 KM

Check
    Drum Brake System
      Check the linings for wear and the wheel cylinders for leakage.
    Disc Brake System
      Check pads for wear. Inspect calipers and hoses for leaks.
Adjust
    Valve Clearance
      Inspect and adjust clearances.
    Idle Speed
      4-cylinder vehicles. Check and adjust if necessary.
Inspect
    Steering
      Check steering linkage seals for wear, damage and leakage.
    Power Steering Fluid
      Check fluid level and condition.
    Fluid - M/T
      Check fluid level and condition.
    Exhaust System
      Check for cracks, corrosion and leakage. Check heat shields for debris.
    Cooling System
      Inspect system and service as necessary.
    Constant Velocity Joint Boot
      Check for wear, damage or leakage.
    Clutch Fluid
      Check fluid level and condition.
    Brake Fluid
      Check fluid level and condition.
    Ball Joint
      Check for wear or damage. Lubricate those equipped with grease fittings. Check for wear or damage. Lubricate those with a grease fitting available.
Replace
    Spark Plug
      Non-platinum plugs. Replace with correct type and gap according to manufacturers specification.
    Oil Filter, Engine
      Replace every 12 months or 10,000 miles. Replace at every other oil change.
    Fluid - Differential
      1987 Limited-Slip differential only. Replace fluid, check for leaks. 1988 Limited-Slip, replace the fluid and check for leaks. Rear-Wheel-Drive differential, check the fluid level and condition.
    Fluid - A/T
      Service fluid and filter. Check for leaks.
    Engine Oil
      Replace every 6 months or 5000 miles. Use oil rated to manufacturers specifications.
    Drive Belt
      Replace water pump and alternator V-belts.
    Air Filter Element
      Extremely dusty conditions may require more frequent service of this component.
Clean/Repack
    Wheel Bearing
      Front bearings on rear-wheel drive cars and rear bearings on front-wheel drive cars. Inspect for leaks and repack whenever discs or drums are removed.
Flush
    Coolant
      Drain, flush and refill system. Check specific gravity for freezing point.
    Choke Housing
      Clean choke assembly and linkages. Check for proper operation.