Km-148 Automatic Transmission W/Transfer Case

1. Drain transmission fluid as described under ``Changing Fluid.''
2. Raise and support vehicle.
3. Remove transmission skid plate and under cover.
4. Remove snap ring and clevis pin, then disconnect throttle cable from transmission.
5. Remove transfer case shift lever knob, then the shift boot retaining plate and boot.
6. Disconnect shift linkage and speedometer cable from transmission.
7. Disconnect inhibitor switch electrical connector from transmission.
8. Mark position of left and right propeller shafts for installation reference, then remove the shafts from transmission.
9. Remove starter motor attaching bolts, then the exhaust pipe mounting bracket.
10. Remove bellhousing cover, then the torque converter-to-drive plate attaching bolts. Rotate crankshaft as necessary to gain access to all six bolts.
11. Disconnect oil cooler lines, then remove filler tube and tube O-ring from transmission.
12. Remove rear engine support insulator and No. 2 crossmember.
13. Remove transfer case mounting bracket and insulator.
14. Support lower part of transmission using a suitable jack, then remove transmission to engine attaching bolts.
15. Move transmission and transfer case rearward and carefully lower assembly from vehicle.
16. Reverse procedure to install. When mounting transmission to engine, ensure transmission attaching bolt holes are properly aligned with lugs on engine.