Codealarm RKE Only

(Port/Dealer installed - Not included in service manual)

NOTE:
For technical assistance on installing and servicing CodeAlarm Systems, call 800-421-3209 Monday-Friday between 8:00 a.m. and 7:00 pm. or Saturday between 10:00 a.m. and 2:00 p.m. Eastern Standard Time.

System Operation:

Push the "1" or "LOCK" button to lock all doors. Push the "2" or "UNLOCK" button to unlock all doors and illuminate the dome light for 60 seconds or until the ignition key is turned to the "ON" position. After the ignition key is turned to the "OFF" position, the dome lamp will remain illuminated for 60 seconds.

Receiver Module Location:
For all models except 1997-98 Diamante, behind knee bolster on driver's side. For 1997-98 Diamante, at base of passenger side "A" pillar.

Ignition Switch Connection:
6-pin ignition switch connector on left side of steering column Ground Connection: Hex bolt on left side kick panel

Courtesy Light Connection:
For all models except 3000GT, at ETACS unit connected to fuse block. On 3OOOGT, under dash on driver's side.

Door Lock Connection:
For all models except 1997-98 Diamante, near the ETACS unit with fuse block. On 1997-98 Diamante models, at engine ECU.

Transmitter Programming:





1. Locate the programming button in the RKE harness near the RKE receiver.

2. Open driver's door. Leave door open until programming is completed.

3. Turn the ignition key to the "ON" position. Press and hold the programming button for about 15 seconds. The power door locks should lock and unlock three times.

4. While still holding the programming button down, press the "1" or "LOCK" button on the first transmitter. The door locks should lock and unlock.

5. While still holding the programming button down, press the "1" or "LOCK" button on the second transmitter. The door locks should lock and unlock.

6. Release the programming button.

7. Turn the ignition key to the "OFF" position.

8. Verify that both transmitters operate properly.