Removal and Installation

REMOVAL SERVICE POINTS

A COMPRESSOR DRIVE BELT REMOVAL

(1) Loosen bolt "A" for holding the tension pulley.
(2) Loosen bolt "B" for adjustment, and remove the compressor drive belt.

B DISCHARGE HOSE AND SUCTION HOSE A REMOVAL

If the hoses are disconnected, cap the hoses with a blank plug to prevent entry of dust, dirt, arid water.

COMPRESSOR REMOVAL

CAUTION: Lay the towel on the brake tube to protect them. When installing the compressor, do not damage the brake tubes. This work must be done carefully so as not to spill the compressor oil.

INSTALLATION SERVICE POINT

A COMPRESSOR INSTALLATION
If a new compressor is installed, first adjust the amount of oil according to the procedures described below, and then install the compressor.
1. Measure the amount [X Cubic.cm (X fl.oz.)] of oil within the removed compressor.
2. Wipe away (from the new compressor) the amount of oil calculated according to the following formula, and then install the new compressor.

New compressor oil amount 160 Cubic.cm - X Cubic.cm = Y Cubic.cm (5.4 fl.oz. - X fl.oz. = Y fl.oz.)

NOTE:
1. Y Cubic.cm (Y fl.oz.) indicates the amount of oil in the refrigerant line, the condenser, the cooling unit, etc.
2. If any other air conditioning part is replaced simultaneously with the compressor, remove the oil from the new compressor, taking the specified amount of oil for the part into consideration.

Quantity
Evaporator: 60 Cubic.cm (2.0 fl.oz.)
Condenser: 15 Cubic.cm (0.5 fl.oz.)
Suction hose: 10 Cubic.cm (0.3 fl.oz.)
Receiver: 10 Cubic.cm (0.3 fl.oz.)