Wiper and Washer Systems: Service and Repair

NOTE: Refer to TSB 03-51-005 for torque revisions.











REMOVAL SERVICE POINT




<> WIPER MOTOR REMOVAL

CAUTION: Auto-stop angle is preadjusted at the factory. Therefore do not remove the crank arm from the wiper motor unless necessary. Should It be removed, mark the crank arm and wiper motor.

Use a flat-tipped screwdriver to disconnect the wiper motor crank arm from the link assembly.

INSTALLATION SERVICE POINT




>>A<< WIPER ARM AND BLADE ASSEMBLY INSTALLATION
Install the wiper blade at the specified position (standard value).

Standard value:
Driver's side: 20 - 30 mm (0.8 - 1.2 inches)
Passenger's side: 30 - 45 mm (1.2 - 1.8 inches)