Rear

WHEEL ALIGNMENT CHECK AND ADJUSTMENT
TOE-IN





Standard value: 3 ± 3 mm (0.12 ± 0.12 inch)
Loosen nut, then turn the toe control arm mounting bolt to adjust toe.
LH: Clockwise viewed from the rear -] Toe-out
RH: Clockwise viewed from the rear -] Toe-in
Toe adjustment can be made at graduations of approximately 2.5 mm (0.10 inch).

CAMBER
Standard value: -1°20' ± 30'

NOTE: Camber is preset at the factory and cannot be adjusted.

NOTE: If camber is not within the standard value, check and replace bent or damaged parts.