Component Tests and General Diagnostics

The radio and tape player does not work under the following conditions.
- Power supply to the radio and tape player has been suspended for more than an hour continuously by removing the cable from the battery terminal or disconnecting the harness connectors.
- The power supply to the radio and tape player has been suspended for more than an hour due to a blown fuse or discharged battery.
- The radio and tape player has been replaced.

If the radio and tape player does not work for these conditions, enter the security code as follows.

NOTE: * Tape player displays "code" or "OFF," CD player displays "CODE" or "OFF".




1. Confirm the security code using any of the following methods.
1. Use the security code indicated on the cards retained by the car.




2. If the security code is unknown owing to the user's loss of the card:
a. Remove the radio and tape player.
b. Read the serial number stamped on the radio and tape player.
C. Look up the security code (anti-theft code table) corresponding to the serial number.




3. When the radio and tape player is replaced:
Use the security code on the cards attached to the upper surface of the replacement radio and tape player.

NOTE: Deliver the two cards to the user.




2. Connect the radio to the vehicle harness.
3. Turn the ignition key to the "ACC" or "ON" position.
4. Press the "POWER" button, and "codE" codeCODE"* will be displayed.




5. Press number 1 through number 4 memory select button to set the four-digit security code shown on the card. Every time each digit key is pressed, the figure changes as follows: 0->1->2->3->4->5->6->7->8->9->0
6. Press the "TAPE" or "CD" button, and a beep will be heard. If entered correctly, the radio and tape player will work.
7. If the security code is not accepted, "1 Err" is displayed. In a few minutes, it will change to "code" or "CODE."* Then repeat steps 5 and 6.

NOTE: The anti-theft system will allow three attempts maximum to input the correct code.

NOTE: The second error is displayed as "2 Err" When the third error is made, "3 Err" is displayed and then the display changes to "OFF" or "OFF"* If this should occur, the unit will not work any more.

NOTE: To input the security code again, turn the ignition switch to the "ACC" or "ON" position and wait for one hour when "OFF" or "OFF"* is displayed. After "OFF" or "OFF"* disappears on the display and changes into "code" or "CODE,"* the security code can be input again.




5-minute operation mode
To facilitate replacement or check, the radio and tape player can be operated for five minutes without inputting the security code.
1. Press the "POWER" button and number 5 memory select button together to operate the radio and tape player.
2. In five minutes the unit will not be able to work, and "code" or "CODE"* will be displayed to indicate that the security code can be input again.