Rear Door: Service and Repair
DOOR ASSEMBLYDoor Assembly:
INSTALLATION SERVICE POINT
]]A[[ STRIKER INSTALLATION
Align the center of the striker and latch within 1.5 mm (0.06 inch), and install.
DOOR PROTECTOR FILM
Door Protector Film:
INSTALLATION SERVICE POINT
]]A[[DOOR PROTECTOR FILM INSTALLATION
1. Installation position
Attach each protector film in the position shown in the illustration.
2. Installation procedure
1. Use 3M(TM) AAD Part number 8906 or equivalent to clean the door protector film installation surfaces on the body.
CAUTION: When attaching the door protector film, the ambient temperature should be 20 ° - 38 °C (60 ° - 100 °F) and the air should be completely free from dust. If the ambient temperature is lower than 20 °C (60 °F) the door protector film and the places on the vehicle body where the door protector film to be attached should be heated to 20 ° - 38 °C (60 ° - 100 °F).
2. Peel off the protection sheet on the back of the door protector film to affix it on the installation position.