Overhaul
DISASSEMBLY SERVICE POINTS
<> ARMATURE AND BALL REMOVAL
CAUTION: When removing the armature, take care not to lose the ball (which is used as a bearing) in the armature end.
<> SNAP RING AND STOP RING REMOVAL
Snap Ring/Stop Ring Removal:
1. Press a long socket wrench of appropriate size to the stop ring. Then tap the socket wrench to move the stop ring to ward the pinion gear.
Snap Ring/Stop Ring Removal:
2. After removing the snap ring (by using snap-ring pliers), slide the stop ring and the overrunning clutch off the pinion shaft.
ASSEMBLY SERVICE POINT
Stop Ring/Snap Ring Installation:
>>A<< STOP RING AND SNAP RING INSTALLATION
Using a suitable pulling tool, pull the overrunning clutch stop ring over the snap ring.