Adhesive Components

INSTALLATION AND REMOVAL OF ADHESIVE COMPONENTS




SIDE AIR DAM

REMOVAL

SIDE AIR DAM REMOVAL

Gently lift and remove the side air dam. If there is any double-side tape remaining on the side air dam, remove according to the following instructions.






1. Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.




2. Scrape off the double-sided tape with a resin spatula as possible.
3. Peel off the protection tape.
4. Use a shop towel moistened with 3M(TM) AAD Part number 8906 or equivalent to wipe the body.






1. Scrape off the double-sided tape on the side air dam with a resin spatula as possible.
2. Use a shop towel moistened with 3M(TM) AAD Part number 8906 or equivalent to wipe the side air dam surface.
3. Remove only a small portion of the residual adhesive.
4. Adhere the double-side tape as specified on the side air dam.

INSTALLATION

SIDE AIR DAM INSTALLATION




1. Tear off the double-sided tape backing paper.

NOTE: If you attach the adhesive tape to the edge of the backing paper, it will be easy to tear off.

2. Install the side air dam.

NOTE: If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding surfaces of the body and side air dam to about 40 - 60 degrees C (104 - 140 degrees F) before affixing the tape.

3. Firmly press in the side air dam.