Operation CHARM: Car repair manuals for everyone.
Home >> Mitsubishi >> 2004 >> Lancer Sportback L4-2.4L SOHC >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Fuel Level Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Level Sensor: Service and Repair

FUEL LEVEL SENSOR REPLACEMENT
1. Remove the rear seat cushion assembly (Refer to Rear Seat Assembly).
2. Pry out the service hole cover.




3. Disconnect the harness connector.

CAUTION: Pay attention not to damage the sensor unit and the float of the fuel level sensor when withdrawing it from the service hole.

4. Remove the fuel level sensor mounting bolts and remove the fuel level sensor from service hole.

NOTE: Check the fuel level sensor (Refer to Combination Meter Assembly - On-vehicle Service). If defective, replace it.

CAUTION: Pay attention not to damage the sensor unit and the float of the fuel level sensor when inserting it from the service hole.

5. Install the fuel level sensor. Tighten the mounting nuts to the specified torque.

Tightening torque: 2.5 ± 0.5 Nm (23 ± 4 in-lb)

6. Connect the harness connector.




7. Apply the specified sealant to the contact surfaces of the service hole cover and the floor pan, and install the service hole cover.
Specified sealant: 3M(TM) 8513 Grommets Windshield Sealer (Black)

8. Install the rear seat cushion assembly (Refer to Rear Seat Assembly).
pro multis · About Operation CHARM