Removal and Installation
The content of this article/images reflect the changes called out by TSB - 04-13-001THROTTLE BODY ASSEMBLY
REMOVAL AND INSTALLATION
CAUTION: Do not loosen the fixing screws for the resin cover of throttle body assembly. If the screws are loosened, the sensor incorporated in the resin cover becomes misaligned and the throttle body can not work normally.
INSTALLATION SERVICE POINT
>>A<< THROTTLE BODY GASKET INSTALLATION
CAUTION: Poor idling etc. may result if the throttle body gasket is installed incorrectly.
Install the gasket as its protrusion is in the direction shown.
The ETV must be initialized after performing any of the following operations:
^ Throttle body installation, removal, or replacement
^ Throttle body cleaning
^ PCM removal, installation, or replacement
^ Battery cable disconnect and reconnect
^ PCM reprogramming
To initialize the ETV, turn the ignition switch to the ON position (do not start engine), then turn it off. Keep it off for at least 10 seconds before starting the engine.