Anti-Lock Braking System (ABS) RWD
CHECK AT ABS-ECUTERMINAL VOLTAGE CHECK CHART
NOTE: Do not measure terminal voltage for approximately three seconds after the ignition switch is turned to the "ON" position. The ABS-ECU performs the initial check during that period.
1. Measure the voltages between terminals (32) or (34) (ground terminals) and each respective terminal.
2. The terminal layouts are shown in the illustrations.
RESISTANCE AND CONTINUITY BETWEEN HARNESS-SIDE CONNECTOR TERMINALS
1. Turn the ignition switch to the "LOCK" (OFF) position and disconnect the ABS-ECU connectors before checking resistance and continuity.
2. Check between the terminals indicated in the table.
3. The terminal layouts are shown in the illustration.