Throttle Cable/Linkage: Adjustments
ACCELERATOR CABLE CHECK AND ADJUSTMENT1. Turn the A/C and lights OFF. Inspect and adjust the accelerator cable at no load.
2. Warm engine until stabilized at idle.
3. Confirm idle speed is at standard value.
Standard value: 700 ± 100 r/min
4. Stop the engine. [ignition switch: "LOCK" (OFF) position.]
5. Confirm there are no sharp bends in the accelerator cable.
6. Check the inner cable for correct slack.
Standard value: 1.0 - 2.0 mm (0.04 - 0.08 inch)
7. If there is too much slack or no slack, adjust play by the following procedures.
1. Loosen the adjusting bolt to release the cable.
2. Move the plate until the inner cable play is at the standard value, and then tighten the adjusting nut.
3. After adjusting, check that the throttle lever is touching the stopper.