Removal and Installation

REMOVAL AND INSTALLATION

CAUTION: When removing and installing the transaxle control cable and shift lock cable unit, be careful not to hit the SRS-ECU.

INSTALLATION SERVICE POINTS
>>A<< SHIFT LOCK CABLE UNIT INSTALLATION





1. Selector lever to "P" position.
2. Turn the ignition key to "LOCK" (OFF) position.
3. Install the shift lock cable unit rod to the selector lever assembly lock cam, and tighten the shift lock cable unit installation bolt to the specified torque.
Tightening torque: 5.0 ± 1.0 Nm (44 ± 9 inch lbs.)
4. Check the selector lever operation.

>>B<< TRANSAXLE CONTROL CABLE ASSEMBLY (TRANSAXLE SIDE)/ADJUSTING NUT INSTALLATION





1. Place the selector lever and manual control lever in the "N" position.
2. Place the cable stud into the manual control lever slot and install the adjusting nut loosely. Gently push the transaxle control cable into the manual control lever slot until the cable is taut. Tighten the adjusting nut to the specified torque.
Tightening torque: 12 ± 2 Nm (107 ± 17 inch lbs.)