Keyless Operation System
DTC C1911: Reception Abnormality 1DTC C1921: Reception Abnormality 2
DTC C1931: Reception Abnormality 3
DTC C1941: Reception Abnormality 4
CAUTION: If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
TPMS DTC SET CONDITION
When KOS-ECU cannot receive the signal from the TPMS transmitter normally, this code is set.
TROUBLESHOOTING HINTS
The most likely causes for this DTC to set are:
- Damaged wiring harness and connector.
- Malfunction of TPMS transmitter.
- Malfunction of KOS-ECU.
DIAGNOSIS
Required Special Tools:
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
MB991824: Vehicle Communication Interface (V.C.I.)
MB991827: M.U.T.-III USB Cable
MB991910: M.U.T.-III Main Harness A
STEP 1. M.U.T.-III CAN bus diagnostics
Use scan tool to diagnose the CAN bus lines.
Q: Is the check result normal?
YES : Check the registered ID by the transmitter ID check function, and detect the wheel to which the DTC is set by the transmitter check function. Then, replace the TPMS transmitter, and register the ID code. If the ID Code of replaced TPMS transmitter cannot be registered, replace the KOS-ECU and register the ID Code. Then go to Step 3.
NO : Repair the CAN bus lines. On completion, go to Step 2.
STEP 2. Diagnostic trouble code recheck after resetting CAN bus lines.
1. Turn the ignition switch to the "ON" position.
2. Check if the DTC is set.
3. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the diagnostic trouble code C1911, C1921, C1931 or C1941 set?
YES : Start over at Step 1.
NO : The procedure is complete.
STEP 3. Recheck for diagnostic trouble code.
1. Turn the ignition switch to the "LOCK" (OFF) position.
2. Turn the ignition switch to the "ON" position.
3. Check if the DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the diagnostic trouble code C1911, C1921, C1931 or C1941 set?
YES : Replace the KOS-ECU and register the ID Codes. Then start over at Step 1.
NO : The procedure is complete.