P0462
DTC P0462: Fuel Level Sensor Circuit Low InputTECHNICAL DESCRIPTION
The fuel level sensor converts the rest of the fuel to a voltage and sends it to the combination meter.
The combination meter sends the data regarding the rest of the fuel to the ECM.
The ECM checks whether this data is within a specified range.
DESCRIPTIONS OF MONITOR METHODS
A short circuit is detected while monitoring the fuel level sensor output.
MONITOR EXECUTION
Continuous
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
Not applicable
Sensor (The sensor below is determined to be normal)
Not applicable
DTC SET CONDITIONS
Logic Flow Chart:
Logic Flow Chart
Check Conditions
Battery positive voltage is between 11 and 16.5 volts.
2 seconds or more have passed since the engine staring sequence was completed.
Judgement Criterion
Fuel level sensor resistance has continued to be lower than 2 ohms for 2 seconds.
OBD-II DRIVE CYCLE PATTERN
Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 24. OBD-II Drive Cycle
TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)
Fuel level sensor failed.
Combination meters assembly failed.
Connector damage
Harness damage
ECM failed.
DIAGNOSIS
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: USB Cable
- MB991910: Main Harness A
STEP 1. Check fuel gauge.
Q: Is the fuel gauge functioning?
YES: Go to Step 2.
NO: Refer to Chassis Electrical - Combination Meters Assembly - Symptom Chart. Symptom Chart
STEP 2. Check the trouble symptoms.
1. Carry out a test drive with the drive cycle pattern. Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 24. OBD-II Drive Cycle
2. Check the diagnostic trouble code (DTC).
Q: Is DTC P0462 set?
YES: Replace the ECM. When the ECM is replaced, register the ID code. Refer to ID Code Registration Judgment Table
NO: It can be assumed that this malfunction is intermittent.
STEP 3. Test the OBD-II drive cycle.
1. Carry out a test drive with the drive cycle pattern. Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 24. OBD-II Drive Cycle
2. Check the diagnostic trouble code (DTC).
Q: Is DTC P0462 set?
YES: Retry the troubleshooting.
NO: The inspection is complete.