P0713

P0713: Transmission Fluid Temperature Sensor System (Open Circuit)

Transmission Fluid Temperature Sensor Circuit (Part 1):

Transmission Fluid Temperature Sensor Circuit (Part 2):

DESCRIPTIONS OF MONITOR METHODS
^ The following conditions are detected: Vehicle speed > 10 km/h (6.2 mph), oil temperature > -40°C (-104°F).

MONITOR EXECUTION
^ Continuous

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
^ Not applicable

Sensor (The sensor below is determined to be normal)
^ Not applicable

LOGIC FLOW CHARTS (Monitor Sequence):

DTC SET CONDITIONS

Check Conditions
^ Vehicle speed: more than 10 km/h (6.2 mph).

Judgement Criteria
^ Value of temperature of transmission fluid: less than -40°C (-104°F). (At once)

OBD-II DRIVE CYCLE PATTERN
Start the engine, drive at more than 60 km/h (37 mph) for 15 minutes in total.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CODE TO BE SET ARE:)
^ Malfunction of the transmission fluid temperature sensor system (open circuit) circuit
^ Damaged harness or connector
^ Malfunction of the transmission fluid temperature sensor system (open circuit)
^ Malfunction of the TCM

DIAGNOSIS

STEP 1. Check the TCM terminal voltage.
[C-37 connector (vehicle side, connected)]
Turn ON the ignition switch, and check the voltage between terminal No. 39 and No. 50.
^ Transmission fluid 20°C (68°F): Approx. 2.52 V
^ Transmission fluid 80°C (176°F): Approx. 0.69 V
Q: Is the check result normal?
YES: Go to Step 6.
NO: Go to Step 2.

STEP 2. Check the transmission fluid temperature sensor as a single unit.
Transmission Fluid Temperature Sensor Check
Q: Is the check result normal?
YES: Go to Step 3.
NO: Replace the valve body assembly.

STEP 3. Check the wiring harness between the transmission fluid temperature sensor and TCM.
Check for continuity between B-111 A/T control solenoid valve assembly connector terminals and C-37 TCM terminals.
^ Between B-111 terminal No. 2 and C-37 terminal No. 39: Continuity exists.
^ Between B-111 terminal No. 3 and C-37 terminal No. 50: Continuity exists.
When the continuity check result is OK, check that the wiring harness is not shorted to the body and other wiring harness.
Q: Is the check result normal?
YES: Go to Step 4.
NO: Repair or replace the failure section.

STEP 4. Check the TCM power supply and ground.
Q: Is the check result normal?
YES: Go to Step 5.
NO: Repair or replace the failure section.

STEP 5. Check the TCM connector pin terminal and the connection status.
Q: Is there a failure point?
YES: Repair or replace the failure section.
NO: Replace the TCM.

STEP 6. Erase the DTC code, and drive the vehicle for a while.
Check that the normal code is displayed.
Q: Is the check result normal?
YES: The procedure is complete.
NO: Return to START.