Operation CHARM: Car repair manuals for everyone.
Home >> Mitsubishi >> 2008 >> Galant V6-3.8L (6G75) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Accelerator Pedal Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Accelerator Pedal Position Sensor: Service and Repair

ACCELERATOR PEDAL

REMOVAL AND INSTALLATION

CAUTION:
- Never loosen the screw fixing the accelerator pedal assembly resin cover. If the screw is loosened, the sensor position which exists inside the resin cover is off and the accelerator pedal position sensor does not work normally.
- Do not remove the accelerator pedal pad. If the pad is removed and installed, excessive force may damage accelerator pedal position sensor.

Removal Steps 1-3:






INSTALLATION SERVICE POINT

]]A[[ ACCELERATOR STOPPER INSTALLATION




1. Insert the accelerator stopper straight into the stud bolt of the floor.
2. Install the accelerator stopper securely by turning it clockwise until its underside contacts with the body bracket as shown in the figure.
3. After the installation, slightly pull the accelerator stopper by hand to check that it cannot be removed easily (appropriate holding power: 100 N or more).
pro multis · About Operation CHARM