A/T

DTC 1706: Accelerator Pedal Position Information

DESCRIPTIONS OF MONITOR METHODS
^ When approx. 1 second has elapsed after TCM started, the throttle pedal position signal seizure is detected for 3 seconds.

MONITOR EXECUTION
^ Continuous

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
^ Not applicable

Sensor (The sensor below is determined to be normal)
^ Not applicable

LOGIC FLOW CHARTS (Monitor Sequence)

Logic Flow Charts (Monitor Sequence):

DTC SET CONDITIONS

Check Conditions
^ TCM is started: more than 1.05 seconds.

Judgement Criteria
^ Communication status: fail. (3 seconds)

OBD-II DRIVE CYCLE PATTERN
Start the engine, and keep the vehicle stopped in "P" range for 5 seconds.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CODE TO BE SET ARE:)
^ Malfunction of the CAN
^ Malfunction of the ECM
^ Damaged harness or connector
^ Malfunction of the throttle position sensor

DIAGNOSIS

STEP 1. Is the DTC code for ECM displayed?
Check that the failure related to the engine does not occur.

Q:Is the check result normal?
YES: Go to Step 2.
NO: Repair or replace the failure section.

STEP 2. Check the throttle position sensor and ECM-side main unit and connector wiring.

Q:Is the check result normal?
YES: Go to Step 3.
NO: Repair or replace the failure section.

STEP 3. Erase the DTC code, and drive the vehicle for a while.
Check that the normal code is displayed.

Q:Is the check result normal?
YES: The procedure is complete.
NO: Return to START.