Oil Pump: Specifications

BALANCER SHAFT AND OIL PUMP MODULE





Tighten the balancer shaft and oil pump module bolts to the specified torque 20 Nm (15 ft-lb) in the order of number shown in the figure.

Tighten the balancer shaft and oil pump module bolts again to the specified torque 44 Nm (33 ft-lb) in the order of number shown in the figure.

Loosen the balancer shaft and oil pump module bolts fully in the reverse sequence to that shown.

Tighten the balancer shaft and oil pump module bolts to the specified torque 20 Nm (15 ft-lb) in the order of number shown in the figure.








After tightening to the specified torque, tighten the balancer shaft and oil pump module bolts to 135°, using special tool MB991614, in the order of number shown in the figure.