Oil Pressure Switch (For Fuel Pump): Service and Repair

ENGINE OIL PRESSURE SWITCH

REMOVAL AND INSTALLATION [2.4L ENGINE]

Pre-removal and Post-installation Operation:

Removal Steps 1-2:

Required Special Tool:
^ MB992118: Oil Pressure Switch Wrench

REMOVAL SERVICE POINTS

[[A]] THROTTLE BODY MOUNTING BOLTS REMOVAL
Remove the throttle body mounting bolts and put the throttle body aside so as not to interfere the oil pressure switch connector disconnection.

[[B]] ENGINE OIL PRESSURE SWITCH REMOVAL

CAUTION: The sealant is applied to the bolt. Remove the bolt with care not to break it.





Use special tool oil pressure switch wrench (MB992118) to remove the engine oil pressure switch.

INSTALLATION SERVICE POINT

]]A[[ ENGINE OIL PRESSURE SWITCH INSTALLATION





1. Apply sealant to the engine oil pressure switch thread.

Specified sealant: Three bond 1215 or equivalent

CAUTION: Do not start the engine for 2 hour or more after the engine oil pressure switch installation.





2. In the same manner as removal, use special tool oil pressure switch wrench (MD992118) to tighten the engine oil pressure switch to the specified torque.

Tightening torque: 10 ± 2 Nm (87 ± 17 in-lb)

REMOVAL AND INSTALLATION [3.0L ENGINE]

Pre-removal and Post-installation Operation:

Removal Steps 1-3:

REMOVAL SERVICE POINT

[[A]] ENGINE OIL PRESSURE SWITCH REMOVAL





Use special tool oil pressure switch wrench (MB992118) to remove the engine oil pressure switch.

INSTALLATION SERVICE POINT

]]A[[ ENGINE OIL PRESSURE SWITCH INSTALLATION





1. Apply sealant to the engine oil pressure switch thread.
Specified sealant: Three bond 1215 or equivalent

CAUTION: Do not start the engine for 2 hour or more after the engine oil pressure switch installation.





2. In the same manner as removal, use special tool oil pressure switch wrench (MB992118) to tighten the engine oil pressure switch to the specified torque.

Tightening torque: 10 ± 2 Nm (87 ± 17 in-lb)