Ignition Switch: Service and Repair
REMOVAL AND INSTALLATIONCAUTION:
- Before removing the steering wheel assembly, refer to SRS Service Precautions and Air Bag Module and Clock Spring
- After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point (Refer to traction control, On-vehicle Service Steering Wheel Sensor Calibration).
Pre-removal & Post-installation Operation:
Removal Steps 1-10 (Part 1):
Removal Steps 1-10 (Part 2):
REMOVAL SERVICE POINT
<> STEERING LOCK CYLINDER REMOVAL
1. Insert the key into the steering lock cylinder, and turn the ignition key to the ACC position.
2. With using a cross-headed screw driver (small) or similar items to press in the lock pin, remove the ignition key, and then remove the steering lock cylinder.
INSTALLATION SERVICE POINT
>>A<< WIRELESS CONTROL MODULE (WCM)
Check that the top claw of receiver antenna module is fixed securely to the boss of steering lock and the antenna is not floated on the key cylinder.