Rear Suspension

CONTROL LINK, UPPER ARM AND LOWER ARM

REMOVAL AND INSTALLATION

CAUTION:
^ The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.
^ The parts indicated by *2 are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.

Post-installation Operation:

Control Link And Upper Arm Removal Steps 1-2 / Lower Arm Removal Steps 3-6:

Control Link And Upper Arm Removal Steps 1-3 / Lower Arm Removal Steps 1-10:

REMOVAL SERVICE POINTS

[A]] CONTROL LINK REMOVAL





Make a mating mark on the toe adjusting bolt, and remove the control link.

INSTALLATION SERVICE POINTS

]]A[[ UPPER ARM INSTALLATION





Install the upper arm so that the hole faces the body side.