ASC

DTC U0001: Bus-off

CAUTION:
^ If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ If diagnostic trouble code 00001 is set in ASC-ECU, always diagnose the CAN bus line. If there is any fault in the CAN bus lines, an incorrect diagnostic trouble code may be set. In this case, the set diagnostic trouble code is not highly reliable.
^ Before replacing the ECU, ensure that the communication circuit is normal.
^ When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor, the G and yaw rate sensor and brake fluid pressure sensor.

DTC SET CONDITIONS
This diagnostic trouble code is set when ASC-ECU has ceased the CAN communication (bus off).

COMMENTS ON TROUBLE SYMPTOM
Malfunction of wiring harness, connector (s), or ASC-ECU may be present.

PROBABLE CAUSES
^ Wring harness or connector failure of CAN bus line
^ ASC-ECU malfunction
^ Other ECU malfunction

DIAGNOSIS

Required Special Tools:
^ MB991958: Scan Tool (M.U.T.-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness

STEP 1. M.U.T.-III CAN bus diagnostics
Use scan tool to diagnose the CAN bus lines.
Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines. On completion, go to Step 3.

STEP 2. Check whether the diagnostic trouble code is reset.
Q: Is DTC U0001 set?
YES: Replace the ASC-ECU, and then go to Step 3.
NO: If the trouble symptom is resolved, an intermittent malfunction such as poorly engaged connector(s) or wiring harness is suspected.

STEP 3. Check whether the diagnostic trouble code is reset.
Q: Is DTC U0001 set?
YES: Return to Step 1.
NO: The procedure is complete.