A/T
DTC U0100: ECM Time-outDESCRIPTIONS OF MONITOR METHODS
^ Open circuit or short circuit occurs in the CAN communication line (CAN_H, CAN_L).
^ Reception from ECM becomes impossible for a specified time or more.
TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CODE TO BE SET ARE:)
^ Damaged harness or connector
^ Malfunction of the CAN communication
^ Malfunction of the ECM
^ Malfunction of the TCM
DIAGNOSIS
STEP 1. Check the CAN communication system malfunction.
^ Check that the CAN system-related DTC code other than U0100 is set.
^ Check if the CAN-related DTC is set with ECM.
^ Check if the failure related to the engine occurs.
Q:Is the check result normal?
YES: Go to Step 2.
NO: Repair or replace the failure section.
STEP 2. Check the CAN communication lines.
[C-38 TCM connector (vehicle side, disconnected)]
Between C-38 terminal No. 10, 11 and the CAN communication lines of ECM: Continuity exists.
When the continuity check result is OK, check that the wiring harness is not shorted to the body and other wiring harness. Also, check for a short circuit between the twisted pair cables.
Q:Is the check result normal?
YES: Go to Step 3.
NO: Repair or replace the failure section.
STEP 3. Check ECM, the TCM connector pin terminal, and the connection status.
Q:Is the check result normal?
YES: Repair or replace the failure section.
NO: Replace the TCM.