Front Door Latch: Service and Repair

DOOR HANDLE AND LATCH

REMOVAL AND INSTALLATION


CAUTION:

- When the door lock key cylinder is replaced by the key set (A) in the figure, register the encrypted code of the bar code attached to the ignition key. Refer to Keyless Operation System (KOS), ID Code Registration Criteria Table the vehicle with KOS, or Wireless Control Module (WCM), ID Code Registration Criteria Table vehicles without KOS.

- When the door lock key cylinder is replaced by the key set (B) in the figure, do not register the encrypted code of the bar code attached to the ignition key. If the encrypted code is registered, the engine cannot start.

Pre-removal & Post-installation Operation:

Removal Steps 1-16 (Part 1):

Removal Steps 1-16 (Part 2):

Removal Steps 1-12 (Part 1):

Removal Steps 1-12 (Part 2):

INSTALLATION SERVICE POINTS

]]A[[ DOOR CHECK INSTALLATION






Install the door check with the following identification marks facing upward.






]]B[[ DOOR INSIDE HANDLE INSTALLATION

When connecting the inside cable to the door inside handle, ensure that the door latch and the inside handle are unlocked.