Intake Manifold Plenum and Throttle Body Assembly
INTAKE MANIFOLD PLENUM AND THROTTLE BODY ASSEMBLYREMOVAL AND INSTALLATION
Removal Steps 1-12:
Removal Steps 13-21:
INSTALLATION SERVICE POINT
]]A[[ INTAKE MANIFOLD PLENUM STAY, REAR INSTALLATION
1. After temporarily tightening the rear intake manifold plenum stay with the installation bolts, check that the intake manifold fastens securely to the cylinder head.
2. Tighten the rear intake manifold plenum stay to the specified torque.
Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)
]]B[[ INTAKE MANIFOLD PLENUM STAY, FRONT INSTALLATION
1. After temporarily tightening the front manifold plenum stay with the installation bolts, check that the intake manifold fastens securely to the cylinder head.
2. Tighten the front manifold plenum stay to the specified torque.
Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)
]]C[[ THROTTLE BODY STAY INSTALLATION
1. After temporarily tightening the throttle body stay with the installation bolts, check that the throttle body fastens securely to the cylinder head.
2. Tighten the throttle body stay to the specified torque.
Tightening torque: 20 ± 5 Nm (15 ± 3 ft-lb)
]]D[[ EXHAUST GAS RECIRCULATION PIPE GASKET INSTALLATION
Install the exhaust gas recirculation pipe gasket so that the tab is positioned as shown in the illustration.